cutter teeth meaning in Chinese
牙轮齿
Examples
- Based on the cutting experiments used by cutter tooth and point - attack pick on the press and cutting simulation test table , the deformation and failure process of coal body are studied by the method of white light digital speckle correlation
摘要采用白光数字散斑相关测定方法，在压力机上，在截割模拟实验台上分别对煤试件进行刀齿、镐齿的截割实验，研究被截割煤体的变形破坏过程。 - Abstract cutter teeth and gear teeth are simplified as mechanical models , the bending deformation at contact nodes is calculated by applying the three - dimension finite element method and analyzing their mechanical condition , the relation curve between shaving force and bending deformation is drawn out
简介：摘要将刀齿和轮齿抽象简化为力学模型，分析其受力状态，并运用三维有限单元法计算各节点的弯曲变形量。 - The results indicate that a stable deformation localization band occurs in the coal cutting course and develops to macroscopic crack ; the deformation localization band is slantwise ; while the cutter tooth is used , the deformation localization develops slowly , and the localization becomes wider and the strain value in the band area higher afterwards ; when the point - attack pick used the localization develops quickly and the localization band becomes narrow and the strain value in the band lower
研究表明：截齿截割煤体过程中，煤体出现稳定的变形局部化带，且最终发展为宏观裂纹；煤体变形局部化带为一个倾斜带：刀齿截割时，变形局部化发展较慢，但产生变形局部化后，局部化带宽且带内应变值较高；而镐齿截割时，变形局部化发展较快，但产生局部化后，局部化带窄且带内应变值不如刀齿高。 - For cutting the composite lock gear with unequal tooth thickness , a study is made on the design method of gear sharper cutter with nonstandard parameter involute tooth profile and noninvolute tooth profile . the cutter tooth arrangement , the choice of teeth number of the cutter and the basic method of cutter design are discussed ; and a new method of choosing deflection factor by using limited area is presented . and the curve of relationship between rear angle on tooth crest and helical angle on tooth side of the cutter is given so as to give a basis for the gear sharper cutter to choose its parameters . to design nonstandard gear sharper cutter by adopting the method mentioned above will simplify the calculation and will increase the efficiency of design
研究加工不等齿厚的非标准参数渐开线齿形，与非渐开线齿形复合的锁闭齿轮插齿刀刀齿的排列、刀具齿数的选择以及刀具设计的基本方法，介绍用限制区域选择插齿刀变位系数的新方法，并给出刀具齿顶后角与侧螺旋角的关系曲线，为插齿刀参数的选择提供依据.结果表明，采用上述方法设计非标准复合齿轮插齿刀，可简化计算和提高设计效率